Hydrophobicity-induced drying transition in alkanethiol self-assembled monolayer—water interface

During the course of our investigation of the electron transfer properties of some redox species through highly hydrophobic long chain alkanethiol molecules on gold in aqueous and non-aqueous solvents, we obtained some intriguing results such as unusually low interfacial capacitance, very high values of impedance and film resistance, all of which pointed to the possible existence of a nanometer size interfacial gap between the hydrophobic monolayer and aqueous electrolyte. We explain this phenomenon by a model for the alkanethiol monolayer—aqueous electrolyte interface, in which the extremely hydrophobic alkanethiol film repels water molecules adjacent to it and in the process creates a shield between the monolayer film and water. This effectively increases the overall thickness of the dielectric layer that is manifested as an abnormally low value of interfacial capacitance. This behaviour is very much akin to the ‘drying transition’ proposed by Lum, Chandler and Weeks in their theory of length scale dependent hydrophobicity. For small hydrophobic units consisting of apolar solutes, the water molecules can reorganize around them without sacrificing their hydrogen bonds. Since for an extended hydrophobic unit, the existence of hydrogen bonded water structure close to it is geometrically unfavourable, there is a net depletion of water molecules in the vicinity leading to the possible creation of a hydrophobic interfacial gap.     

Quantum diffusion

Basic ideas and results which characterize quantum diffusion of defects in quantum crystals like solid helium as a new phenomenon are presented. Quantum effects in such media lead to a delocalization of point defects (vacancies, impurities etc.) and they turn into quasiparticles of a new type—defectons, which are characterized not by their position in the crystal lattice but by their quasimomentum and dispersion law. Defecton-defecton and defecton-phonon scattering are considered and an interpolation formula for the diffusion coefficient valid in all interesting temperature and concentration regions is presented. A comparison with the experimental data is made. Some alternative points of view are discussed in detail and the inconsistency of the Kisvarsanyi-Sullivan theory is shown.     

Compulsorily Phase Locked Interferometer Using Orthogonally Polarized Light Source of a Modulated LD with High Extinction Ratio

This paper describes a compulsorily phase locked differential interferometer using an orthogonally polarized light source of a modulated LD with high extinction ratio to reduce non-linearity of the interferometer caused by polarization cross-talk. The current modulated LD is used as a light source to make the interferometer compact and for the scanning phase of the interferometer. The interferometer is operated compulsorily at the maximum inclination point of the fringe intensity curve by fringe scanning and an electric system. A Wollaston prism of high extinction ratio (50 dB) is used to combine the polarizing beams and to make the polarization cross-talk very small. In one light source the polarized output beams are on the same propagation axis; in the other they have a small crossing angle (2.5 mrad ∼ 10 mrad) to completely exclude non-linearity of the interferometer causded by polarization cross-talk. Using jets of a gas mixture of nitrogen and ethylene, this interferometer was demonstrated to be useful in detecting the photothermal effect of a photothermal velocimeter under phase fluctuation in a turbulent flow.     

Extraction-ability and -selectivity of tetra-aza-crown ethers for transition metal cations

In order to investigate the relative effects of the differences between the structures and lipophilicities of 1, 10-dioxa-4, 7, 13, 16-tetra-azacyclo-octadecane (TA-18-crown-6) and the tetrabenzyl derivative of 1,10-dioxa-4, 7, 13, 16-tetra-azacyclo-octadecane (TBTA-18-crown-6) on their extraction-abilities and -selectivities for transition metal cations, constants of the overall extraction (logK _ex) of 1:1 (M:L) complexes, the distribution (K _D) for two diluents (CH₂Cl₂ and CHCl₃) with different dielectric constants have been determined at 25 ± 0.1 °C. The magnitude of logK _ex is largely determined by that of K _D. The equilibrium constants of TA-18-crown-6 have been compared with those of TBTA-18-crown-6. It is found that:(i) logK _ex sequences of TA-18-crown-6 and TBTA-18-crown-6 for transition metals in CH₂Cl₂ lie in order: Fe³⁺ > Cu²⁺ > Mn²⁺ > Co²⁺ > Cd²⁺ > Ni²⁺ > Zn²⁺ and Fe³⁺ > Cu²⁺ > Co²⁺ > Mn²⁺ > Ni²⁺ > Cd²⁺ > Zn²⁺ respectively; (ii) the stability sequences of two types of tetra-aza-crown ethers with the transition metal cations in CHCl₃ are the same as follows: Fe³⁺ > Ni²⁺ > Cu²⁺ > Co²⁺ > Zn²⁺ > Cd²⁺ > Mn²⁺, and (iii) unusual selectivities are observed for transition metal-tetra-aza-crowns, e.g. the high Fe³⁺/M ⁿ⁺ selectivity factors (S_f) of TA-18-crown-6, except for the competitive-extractions for the special case in CHCl₃ of TBTA-18-crown-6, it was found that the Mn²⁺/M ⁿ⁺ values were relatively higher according to the other transition metal cations. A systematic sequence in these two types of solvents is not found for a given transition metal cation in terms of the variation of selectivity with the tetra-aza-crown ethers. The results provide alternatives for the rational design of other specific ligands on the transition metal cations.     

Design of an experimental procedure for energy evaluation from biomass

The rational and sustainable exploitation of nature resources is one of the priority objectives of our society. In this article a method is proposed to evaluate and exploit the energetic resources contained in different forest formations. This method is based on the use of a combustion bomb calorimeter to determine the calorific values of the different samples studied. These results were complemented with chemical analysis of the samples and with environmental and geomorphological studies of the zones were samples were taken. The results obtained during the last 3 years for the residual biomass originated from the forest formations existing in Galicia ensure the reliability and usefulness of the method that can be extended to any forest formation all over the world.     

Representations of Positive Projections II

In this paper we obtain a number of Maharam-type slice integral representations, with respect to scalar measures, for positive projections in Dedekind complete vector lattices and f-algebras. AMS Classification: 47B65, 46A40, 06F25     

Leptonic constant of the pseudoscalar <Emphasis Type="Italic">B</Emphasis><Subscript><Emphasis Type="Italic">c</Emphasis></Subscript> meson

We calculate the leptonic constant for the pseudoscalar ground state of the B _c meson in the framework of a QCD-motivated potential model taking into account the two-loop anomalous dimension for the heavy quark current in nonrelativistic QCD as matched with full QCD.     

Fonctions analytiques Cliffordiennes

We define analytic functions within Clifford Algebras CL, and study their trigonometric properties. We write the addition formulas when their arguments, A and B in CL, commute, this generalizes ordinary trigonometry. We examine in particular the case A² = 1.      

Isometric Isomorphisms Between Banach Algebras Related to a Certain Class of Clifford Topological Semigroups

In the present paper it is shown that if S₁ and S₂ are two Clifford topological semigroups satisfying certain conditions and T is an isometric isomorphism of LUC(S₁*) onto LUC(S₂*), then T maps S₁ topologically isomorphically onto S₂. Furthermore, T maps M ^l _n(S₁) (M(S₁), respectively) isometrically isomorphically onto M ^l _n(S₂) (M(S₂), respectively). Indeed, we have obtained a generalization of a well-known result of Ghahramani, Lau and Losert for locally compact groups to a more general setting of Clifford topological semigroups.     

Experiences in Expert Systems

This paper describes some work carried out in the Scientific Research and Development Branch (SRDB) of the Home Office, intended to contribute to an overall aim of building up internal expertise in the field of expert systems. This was done by carrying out a number of pilot and demonstrator projects, two of which are described in some detail. The plan, which proved successful, was to build as far as possible on the relevant skills already possessed by an OR group in the branch. The lessons learned from these are summarized in the hope that they will be of use to other groups who wish to become involved in this important area.